HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

Installing and Configuring HSG Agent
140 HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
The computer scans the I/O bus for Command Console LUNs. The following
is an example of the information that may be shown:
========================
Scanning I/O Bus on nodes: hpk400a
Processing Host hpk400a
Node HW Path Driver Device
-------- -------------------- ---------- --------
hpk400a 10/8.8.0.255.3.15.0 sdisk HSGCCL
hpk400a 10/8.8.0.255.4.1.0 sdisk HSGCCL
Found 2 Command Console LUNs on host hpk400a.
To remove a CCL enter: “r hardware_path”, to add enter “a”
Would you like to Add, Remove or Continue? [a,r,C]
4. Select option C and press Enter.
If the software does not detect any Command Console LUNs (CCL), answer a
and select the hardware path from the list. You should not include the CCLs
for the RA3000 because they are not supported by this Agent. Note that the
disc3 driver indicates that this CCL is on an HP-PB bus. The SPT driver is
attached to this hardware path and requires this node to be rebooted.
5. If you do not need to add or delete CCLs, select option C and press Enter to
continue.
The following is an example of the information that may be displayed:
Completed checking pass thru driver installation and special
files.
Updating storage.ini files for each host.
Creating storage.ini files for each host.
HSG80 0 ZG61701016 ZG62001218 V85L c6t2d0 c6t2d0
6. Enter a subsystem name.
7. Enter the desired monitoring period in seconds:
The following is displayed:
Would you like to enable mail notification? [Y,n]
Configure Email Notification
8. Select Y and press Enter.
The following is displayed:
Adding a User for Mail Notification
Enter the email address of the user or CTRL-C to cancel: