HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

Installing and Configuring HSG Agent
143HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
Note: You can change the configuration of the Agent at any time. For more
information, see "Configuring the Agent for an Alternate Path", page 148.
Installing and Configuring the Agent with MC/ServiceGuard
All hosts in the MC/ServiceGuard cluster must be entered into their /rhosts file,
the
host_name root of all hosts in the cluster. This action enables access by the
root account.
Note: All members of the cluster must be remotely accessible before the installation can
be successfully completed.
1. If you plan to install the Agent into a MC/ServiceGuard package, selection 2
should be used even if pass-through drivers are not installed.
Note: The Client and the Agent must specify the same port numbers for “spgui” and
“spagent.” It is imperative that the numbers entered here are consistent with all other
Client and Agent applications throughout your network enterprise.
2. Specify the port number used for the Client to communicate with the Agent. If
the default port is already used, select option N to specify a new
even-numbered port.
3. Specify the port number for the Agent to send notifications to the Client. If the
default port is already used, select option N and specify a new port (port
specified above +1).
4. To configure the subsystem using the Storage Window, you need to set a
password. The install program does not echo the information that you enter.
Note: The Agent can operate with other SNMP applications. For this reason, it needs
information about the Agent manufacturer and the Enterprise object identifier for use
with its MIB.
5. Enter Compaq Computer Corporation as the Agent manufacturer.