HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

FC Configuration Procedures
154 HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
Figure 41: Single controller cabling
Configuring a Single Controller Using CLI
To configure a single controller using CLI involves the following processes:
■ "Verifying the Node ID and Check for Any Previous Connections", page 154
■ "Configuring Controller Settings", page 155
■ "Restarting the Controller", page 156
■ "Setting Time and Verifying All Commands", page 157
■ "Plugging in the FC Cable and Verifying Connections", page 159
■ "Repeating Procedure for Each Host Adapter", page 159
■ "Verifying Installation", page 159
Verifying the Node ID and Check for Any Previous Connections
1. Enter a SHOW THIS command to verify the node ID:
SHOW THIS
See "Worldwide Names (Node IDs and Port IDs)", page 60, for the location of
the sticker.
1 Controller
2 Host port 1
3 Host port 2
4 Cable from the switch to the host Fibre Channel
adapter
5 FC switch
CXO6881B
1
5
5
3
2
4
4