HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

About this Guide
16 HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
Chapter Content Summary
Table 1 below summarizes the content of the chapters.
Table 1: Summary of chapter contents
Chapters Descriptions
1. Planning a Subsystem This chapter focuses on technical terms
and knowledge needed to plan and
implement storage array subsystems.
2. Planning Storage Configurations Plan the storage configuration of your
subsystem, using individual disk drives
(JBOD), storageset types (mirrorsets,
stripesets, and so on), and/or
partitioned drives. This chapter
describes addressing conventions,
configuration rules, creating storage
profiles, and creating storage maps.
3. Preparing the Host System How to prepare your HP-UX host
computer to accommodate the HSG80
controller storage subsystem.
4. Installing and Configuring HSG
Agent
The Agent for HSG for a specific
operating system polls the storage.
5. FC Configuration Procedures How to configure a subsystem that uses
Fibre Channel (FC) fabric topology. In
fabric topology, the controller connects
to its hosts through switches. How to
verify that LUNs (virtual disk units) are
being correctly presented to HP-UX.
6. Using CLI for Configuration How-to example of configuring a
storage subsystem using the Command
Line Interpreter (CLI).