HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

Installing, Configuring, and Removing the Client
227HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
Before You Install the Client
1. Verify that you are logged into an account that is a member of the
administrator group.
2. Check the software product description that came with the software for a list
of supported hardware.
3. Verify that you have the SNMP service installed on the computer. SNMP
must be installed on the computer for this software to work properly. The
Client software uses SNMP to receive traps from the Agent. The SNMP
service is available on the Windows NT, Windows 2000, and Windows
Server 2003 installation web kit. To verify that you have the SNMP service:
— For Windows NT, double-click Services in Start > Settings > Control
Panel. The entry for SNMP is shown in this window. If you install the
SNMP service and you already have Windows NT Service Pack 6A on
the computer, reinstall the service pack after installing the SNMP service.
— For Windows 2000 and Windows Server 2003, click Start > Settings >
Control Panel > Administrative Tools > Services. The entry for SNMP
is shown in the Services window.
4. Read the release notes.
5. Read "Installing the Integration Patch", page 229, in this appendix.
6. If you have the Command Console Client open, exit the Command Console
Client.
7. If you have Command Console Client V1.1b or earlier, remove the program
with the Windows Add/Remove Programs utility.
8. If you have a previous version of Command Console, you can save the
Navigation Tree configuration by copying the
SWCC2.MDB file to another
directory. After you have installed the product, move
SWCC2.MDB to the
directory to which you installed SWCC.
9. Install the HS-Series Agent. For more information, see Chapter 4.