Compaq StorageWorks UltraSCSI RAID Enclosure (DS-BA370 Series) User's Guide (EK-BA370-UG. C02, September 1998)

Single-Ended I/O Module
5–14 UltraSCSI RAID Enclosure
10. On the expansion enclosure shroud, align the module that has Cable
A (C
ALLOUT
A) attached with the
Port 1
backplane connector.
Gently insert the module and fully seat it. Use a screwdriver to
tighten the spring-loaded mounting screws.
11. Repeat steps 5 through 10 for the remaining SCSI buses (ports 2
through 6).
12. Turn O
N
the subsystem using Table 5–7 and verify that it is operating
properly.
Table 5–6 Installing Two-Enclosure Subsystem
Cables (Continued)
CXO5840B
642
531
642
531
A