Compaq StorageWorks UltraSCSI RAID Enclosure (DS-BA370 Series) User's Guide (EK-BA370-UG. C02, September 1998)

Single-Ended I/O Module
5–18 UltraSCSI RAID Enclosure
7. On the master enclosure shroud, align the module that has Cable A
(C
ALLOUT
A) attached with the
Port 1
backplane connector. Gently
insert the module and fully seat it. Use a screwdriver to tighten the
spring-loaded mounting screws.
8. On the
first
expansion I/O
module, align the
Cable A
(C
ALLOUT
A) connector
with the
left
connector
.
Gently insert the cable
connector into the module
connector. Tighten both
cable connector thumb
screws to fully seat the
connector.
9. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
10. Using the expansion I/O module in step 8, align the
Cable B
(C
ALLOUT
B) connector with the
right
connector. Gently insert the
cable connector into the module connector. Tighten both cable
connector thumb screws to fully seat the connector.
Table 5–8 Installing Three-Enclosure Subsystem
Cables (Continued)
642
531
A
CXO5854B
A
CXO5855B
B