Compaq StorageWorks UltraSCSI RAID Enclosure (DS-BA370 Series) User's Guide (EK-BA370-UG. C02, September 1998)

Single-Ended I/O Module

5–22 UltraSCSI RAID Enclosure

Table 5–10 Installing an I/O Module

1. Verify that the I/O

module being installing is

a model

DS–BA35X–MN.

Note

Jumpers are factory installed—do not modify jumper settings.

2. Align the cable with the

left

I/O module connector.

Gently insert the cable

connector into the module

connector. Tighten both

cable connector thumb

screws to fully seat the

connector.

3. Install a wire tie through the holes on the cable support bracket and

around the cable. Tighten the wire tie.

4. If attaching a cable to the

right

I/O module connector is necessary,

repeat steps 2 and 3 using the

right

I/O module connector.

5. Align the I/O module with the backplane connector in the enclosure

shroud. Gently insert the module and fully seat it. Use a screwdriver

to tighten the spring-loaded mounting screws.

6. Turn O

the subsystem using Table 5–7 and verify that it is operating

properly.

CXO5816A

CXO5940A