Compaq StorageWorks UltraSCSI RAID Enclosure (DS-BA370 Series) User's Guide (EK-BA370-UG. C02, September 1998)

Single-Ended I/O Module

5–24 UltraSCSI RAID Enclosure

Table 5–12 Installing an Expansion Cable

1. Verify that the expansion cable is

the proper type and length per

Table 5–4.

2. Align the cable with the

left

I/O module

connector. Gently insert

the cable connector into

the module connector.

Tighten both cable

connector thumb screws

to fully seat the

connector.

3. Install a wire tie through the holes on the cable support bracket and

around the cable. Tighten the wire tie.

4. Repeat steps 2 and 3 for the other end of the cable. This end of the

cable might connect to a

left

right

I/O module connector,

depending on the enclosures involved.

5. Align the I/O module with the backplane connector in the enclosure

shroud. Gently insert the module and fully seat it. Use a screwdriver

to tighten the spring-loaded mounting screws.

6. Turn O

the subsystem and verify that it is operating properly.

CXO5702A

CXO5940A