HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
112 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Copies the subsystem configuration information from the configuration file saved
on disk into the NVRAM of “this controller.” This command locates the most
recent configuration file saved on disk and restores it. This command causes a
reboot and takes effect immediately.
Note: Use this command for a single-controller configuration only. HP does not
recommend using this command for controllers in a dual-redundant configuration.
Before using the CONFIGURATION RESTORE command, HP recommends that
you use the controller OCP while inserting the controller into its connector slot to
reset it. Refer to controller replacement procedures for single-controller
subsystems in the HP StorageWorks HSG60 and HSG80 Array Controller and
Array Controller Software Maintenance and Service Guide.
Caution: If a disk is moved from one subsystem to another, and it contains
configuration information, perform a CONFIGURATION SAVE command to
synchronize the new disk with the subsystem configuration.
Tip: To initiate the CONFIGURATION RESTORE command from the controller OCP:
1. Push and hold Port #6 button, and then momentarily press the Reset button.
2. Continue holding the Port #6 button until the Port #6 button LED starts flashing.
3. Release the Port #6 button.
CONFIGURATION RESTORE