HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
113HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Tip: If the controller you are installing was previously used in another subsystem, the
controller restarts with the configuration that resides in its nonvolatile memory. If this
differs from the current configuration of the subsystem, you can purge the controller’s
old configuration with the following command:
CONFIGURATION RESET
After invoking the CONFIGURATION RESET command, press the Reset button to
start the controller and then submit the CONFIGURATION RESTORE command to
restore the current configuration.
Note: For single-controller configurations, the INITIALIZE container-name
SAVE_CONFIGURATION command must be used to save controller configuration
information to a disk in order to reset the configuration or to restore the configuration
(see the commands on page 109, page 144, page 115, and page 139 for more
information).
Syntax
CONFIGURATION RESTORE
Parameters
There are no parameters associated with this command.
Switches
There are no switches associated with this command.
Example
To restore the subsystem configuration into the memory of the controller in a
single-controller subsystem, enter:
CONFIGURATION RESTORE