HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
165HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Renames a specified container or specified host connection.
Note: Units, remote copy sets, and association sets cannot be renamed.
Syntax
RENAME old-container-name new-container-name
Parameters
The following parameters support the RENAME command:
■ old-container-name
■ new-container-name
These parameters are described in the following paragraphs.
old-container-name
Specifies the existing name of the container or host connection.
new-container-name
Assigns the new name for the container or host connection.
A name of a host connection can be any combination of letters and numbers,
with the one restriction that it cannot take the form of the default assigned by
the controller (!NEWCONnn).
Switches
There are no switches associated with this command.
Example
To change the name of DISK10000 to MYDISK, enter:
RENAME DISK10000 MYDISK
RENAME