HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
170 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Runs the specified diagnostic or utility program on “this controller.”
Syntax
RUN program-name
Parameter
The following parameter supports the RUN command:
program-name
Specifies the name of the diagnostic or utility program to be run. The
following programs can currently be run:
■ CHVSN—This is not a user utility. This utility is used by HP authorized
service providers only.
■ CLCP—A utility used to load updated software or patches.
■ CLI (Command Line Interface)—A utility that allows the entry of the CLI
commands into the controller.
■ CLONE—A utility used to automate the process of mirroring units to
create a snapshot copy of host unit data.
■ CLONEW—A utility used in the same manner as the CLONE utility,
except that it uses the linked WWID associated with the source unit
instead of allocating a new one.
■ CONFIG—A utility used to locate and add devices to the controller
configuration. The CONFIG utility can be run anytime new devices are
added to the subsystem.
■ DILX—A utility used to test and verify the controller operation with
attached storage devices under a high or low I/O load. Run DILX (Disk
Inline Exerciser) only if there is no activity on the controller. The total I/O
load is handled by the controller, bypassing the host.
The DILX utility has two modes: Autoconfigure mode and Standard
mode.
RUN