HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
184 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Changes specified switch values on the specified controller.
Note: After submitting the SET controller command to either controller, use a
SHOW THIS_CONTROLLER and a SHOW OTHER_CONTROLLER command to verify
that changes went into effect.
Syntax
SET controller
Parameter
The following parameter is associated with this SET command:
controller
Identifies which controller is to be set. Specify THIS_CONTROLLER (the
one connected to the CLI maintenance terminal) or OTHER_CONTROLLER.
“This controller” indicates the controller that is connected to the maintenance
terminal while executing CLI commands. “Other controller” is the controller
not connected to the maintenance terminal in dual-redundant controller
configurations.
Switches
Table 6 lists the switches available with this command. Descriptions of the
switches follow the table.
SET controller
Table 6: SET controller Switches
Switch Value
ALLOCATION_CLASS 0-4,294,967,295, 0 (default)
CACHE_FLUSH_TIMER=n 1-65,535, 10 (default)
COMMAND_CONSOLE_LUN
NOCOMMAND_CONSOLE_LUN
None