HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions

194 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software

Command Line Interface Reference Guide

PORT_1_TOPOLOGY=FABRIC

PORT_2_TOPOLOGY=FABRIC

Specifies switch topology for a host port. This switch is used only in Fibre

Channel switch (FC-SW) topology.

PORT_1_TOPOLOGY=LOOP_HARD

PORT_1_TOPOLOGY=LOOP_SOFT

PORT_1_TOPOLOGY=OFFLINE

PORT_2_TOPOLOGY=LOOP_HARD

PORT_2_TOPOLOGY=LOOP_SOFT

PORT_2_TOPOLOGY=OFFLINE

Indicates whether the user or controller selects the AL-PA for a host port, or

whether the port is to be set offline (used only in AL-PA (FC-AL-PA)

topology). LOOP_HARD allows you to pick the AL-PA. LOOP_SOFT

requests the controller to pick the AL-PA. OFFLINE sets the host port offline.

Specify OFFLINE for a port not in use.

Note: If a topology is already selected, topology must be set to offline before another

topology is selected.

PROMPT=“new prompt”

Specifies the alpha-numeric characters that are displayed if the ACS CLI

prompts for input. This display (prompt) can be from 1-16 characters in length

(only printable ASCII characters and spaces). The new prompt name must be

enclosed within quotes. If changed, the new text entered for this switch takes

effect immediately.

REMOTE_COPY=node-name

NOREMOTE_COPY

Determines whether a controller pair operates in Remove Copy mode.

Note: This command works in a remote copy environment and requires ACS V8.8-

Using either remote copy switch causes the controller to restart.

No other switch can be specified in the same command with the remote copy switches.