HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
208 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Sets operating parameters for the environmental monitoring unit (EMU) in a
BA370 enclosure.
In subsystems with more than one BA370 enclosure, and therefore more than one
EMU, the SET EMU command controls both the master and slave EMU settings.
The EMU within the primary enclosure instructs the EMUs within the other
enclosures to operate at the same settings as the master EMU.
Syntax
SET EMU
Parameters
There are no parameters associated with this command.
Switches
The following switches support the SET EMU command:
■ ALARM
■ FANSPEED
■ SENSOR_n_SETPOINT
These switches are described in the following paragraphs.
ALARM=silent
ALARM=audible
Determines whether the audible alarm of the EMU sounds in the following
cases:
■ Drive failure
■ Controller restart
The EMU alarm still sounds in the event of an adverse environmental
condition, such as a power failure or an over-temperature condition.
SET EMU