HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
222 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
■ Specify THIS_CONTROLLER to copy the device configuration
information from the “this controller” to “other controller.”
■ Specify OTHER_CONTROLLER to copy the device configuration
information from the “other controller” to “this controller.”
Due to the amount of information being passed from one controller to the
other, this command can take up to two minutes to complete.
Example
This example shows how to configure a controller pair to operate in Multiple-bus
Failover mode:
SET MULTIBUS_FAILOVER COPY=THIS_CONTROLLER
The configuration on “this controller” is automatically copied to the “other
controller” after you issue the SET MULTIBUS_FAILOVER command. If you
want to set the preferred path of specific units to specific controllers, use the
following command after setting multiple bus failover:
SET D100 PREFERRED_PATH=THIS_CONTROLLER
SET D101 PREFERRED_PATH=OTHER_CONTROLLER
See Also
SET NOFAILOVER
SET NOMULTIBUS_FAILOVER