HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Introduction
46 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
■ SHOW association-set-name
■ SHOW REMOTE_COPY_SETS
■ SHOW remote-copy-set-name
■ SITE_FAILOVER
Getting help
To get help with using the CLI commands, enter HELP at the CLI prompt. The
resulting display shows an overview of the CLI Help System. To obtain help with
a specific command or to determine which switches are available with a
command, enter as much of the command syntax that is known, followed by a
space and a question mark.
For example, to get information on the switches used with the SET
THIS_CONTROLLER command, enter:
SET THIS_CONTROLLER=?
To see what is allowed for a prompt, enter the following:
SET THIS PROMPT=?
Entering CLI commands
Use the following tips and techniques for entering CLI commands:
■ Commands are not case-sensitive.
■ For most commands, only enter enough of the command to make the
command unique. For example, SHO is the same as entering SHOW.
■ The controller processes each command in sequence, regardless of the
number of commands entered. A controller experiencing heavy data I/O
might respond slowly to CLI commands.
Specific keys or a combination of keys allow the ability to recall and edit the last
four commands. This feature can save time and help prevent mistakes if you are
entering similar commands during the configuration process. Table 3 on page 47
lists the keys used to recall and edit commands.