HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
64 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
The disk-name can consist of a maximum of nine printable characters,
excluding commas and backslashes.
A disk drive is commonly named DISKpttll, where pttll is the disk
port-target-LUN address. Although other naming conventions are acceptable,
this naming convention presents the type of disk drive and the disk drive SCSI
location.
scsi-port-target-lun
Indicates the SCSI device PTL address. Place at least one space between the
port number, target number, and LUN number if you are entering the PTL
address.
■ port—Designates the SCSI device port number, from 1 to 6, on which
the disk resides.
■ target—Designates the SCSI target ID of the disk on the port. Valid
device target IDs for single controller configurations are 00–15,
excluding ID 7. Valid device target IDs for dual controller configurations
are 00–15, excluding IDs 6 and 7.
■ lun—Indicates the LUN of the disk drive and is always zero.
The parameters port, target, and lun must be entered with at least one space
between them. Leading zeroes can be excluded.
Switches
The following switches support the ADD DISKS command:
■ TRANSFER_RATE_REQUESTED=
■ TRANSPORTABLE and NOTRANSPORTABLE
These switches are described in the following paragraphs.
TRANSFER_RATE_REQUESTED=
Specifies the maximum data transfer rate at which the controller is to
communicate with the disk drive. The transfer rate might need to be limited to
accommodate long cables between the controllers and the device. Transfer
rate options include the following:
■ ASYNCHRONOUS
■ DEFAULT