HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
65HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
■ 20MHZ (default)
■ 10MHZ
■ 5MHZ
TRANSPORTABLE
NOTRANSPORTABLE (default)
Indicates whether a disk drive can be accessed exclusively by HSG60 or
HSG80 controllers or can be used by non-HP StorageWorks systems:
■ Specify TRANSPORTABLE to allow disk drives to be moved to non
HP StorageWorks environments while keeping data intact. Disk drives do
not contain any metadata or restricted areas. Therefore, transportable
disks forfeit the advantage metadata provides. Disks that are to be used in
storagesets cannot be set as transportable.
■ Specify NOTRANSPORTABLE to allow disk drives to be moved to only
HP StorageWorks environments. The controller makes a small portion of
the disk inaccessible to the host. This restricted space is used to store
administrative information (metadata) used to improve data reliability,
error detection, and the ability to recover data.
If you specify the NOTRANSPORTABLE switch and there is no metadata on
the unit, the unit must be initialized. If you specify TRANSPORTABLE for a
disk that was originally initialized as a NOTRANSPORTABLE, you should
initialize the disk.
Note: HP recommends that you avoid using transportable disks unless there is no
other way to move the data.
Examples
To add DISK10000 at port 1, target 0, LUN 0, enter:
ADD DISKS DISK10000 1 0 0
To add DISK40200 as a transportable disk drive to port 4, target 2, LUN 0, enter:
ADD DISKS DISK40200 4 2 0 TRANSPORTABLE