HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
78 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Creates a remote copy set (RCS) consisting of one unit at the initiator site and one
unit at the target site. The units can be a single disk (JBOD) or a stripeset,
mirrorset, or RAIDset.
Note: This command works only in a DRM environment and requires an HSG80
array controller with ACS V8.8-
x P. Like all DRM commands, use of this command is
heavily restricted. Refer to the latest version of the Operations Guide for the HP
StorageWorks Data Replication Manager application for examples of usage.
This command can only be used on the initiator (local) site.
The following restrictions apply to remote copy sets:
■ There is a maximum of 12 remote copy sets per initiator and target pair.
■ Neither initiator nor target units can be transportable units, concatset units, or
snapshot units.
Syntax
ADD REMOTE_COPY_SETS remote-copy-set-name
initiator-unit-name remote-node-name\target-unit-name
Parameters
The following parameters are required for the ADD REMOTE_COPY_SETS
command:
■ remote-copy-set-name
■ initiator-unit-name
■ remote-node-name\target-unit-name (this parameter is not
required; it can be added later through the SET command)
These parameters are described in the following paragraphs.
remote-copy-set-name
Identifies the name by which the remote copy set is known. This name must
be unique across the fabric.
ADD REMOTE_COPY_SETS