HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
85HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Names a stripeset and adds it to the controller configuration. A stripeset can
contain from 2 to 24 members. Stripesets are also referred to as RAID level 0
storagesets. The number of members in the stripeset is determined by the number
of container-name parameters specified.
Note: The maximum size of a stripeset is 1.024 TB (1,024 GB). The size of a stripeset
is approximated by multiplying the size of the smallest member by the number of
members in the stripeset.
Syntax
ADD STRIPESETS stripeset-name container-name1
container-name2 [container-nameN]
Parameters
The following parameters are required for the ADD STRIPESETS command:
■ stripeset-name
■ container-name
These parameters are described in the following paragraphs.
stripeset-name
Assigns a name to the stripeset. This is the name used with the ADD UNITS
command to identify the stripeset as a host-addressable unit.
The stripeset-name can consist of up to nine characters, excluding
commas and backslashes.
It is common to name a stripeset STRIPEn, where n is a sequentially
assigned, unique identifier. This naming convention presents to the user both
the type of container and its unique identifier.
ADD STRIPESETS