HP StorageWorks HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide (AA-RV1VA-TE, March 2005)

Preparing the Host System
114 HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide
2. Type one of the following commands at the command prompt, depending on
your operating system version.
For Tru64 UNIX Version 4.0x, type:
# mount -r -t cdfs -o rrip /dev/rz6c /mnt
Substitute for rz6c, if necessary, for your CD-ROM.
For Tru64 UNIX Version 5.1x, type:
# mount -r -t cdfs -o rrip /dev/disk/cdrom0c /mnt
Substitute for cdrom0c, if necessary, for your CD-ROM.
3. Change directories on the CD-ROM by typing:
# cd /mnt/agent
4. To run the installation program, type the following at the command prompt:
# setld -l . ( -l is a lowercase L)
You are asked if you want to install the listed subsets.
5. Enter the corresponding number of the software and then press RETURN.
6. Select option y, and then press RETURN.
7. Follow the instructions on the screen.
Upgrading the Agent and ACS on Standalone Servers
1. For any Tru64 UNIX version supported, stop the Agent by using the following
steps:
a. Stop I/O to your FC drives.
b. Unmount your FC drives using the
umount command.
c. Stop the Agent by typing the following commands:
# cd /usr/opt/SWCCXXX/scripts
# execute swcc_config
d. From the SWCC Agent Configuration Utility choose 7) to disable the
Agent (
Steamd)
2. To delete the Agent configuration files, type the following:
# setld -d SWCCXXX
At the prompt:
Answer Y - Your configuration files will be deleted.