HP StorageWorks HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide (AA-RV1VA-TE, March 2005)

Installing and Configuring the HSG Agent
133HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide
Note: For serial and SCSI connections, the Agent is not required for creating virtual
disks.
Installation and Configuration Overview
Table 15 provides an overview of the installation.
Table 15: Installation and Configuration Overview
Step Procedure
1. Verify that your hardware has been set up correctly. See the previous
chapters in this guide.
2. Verify that you have a network connection for the Client and Agent
systems.See “About the Network Connection for the Agent” on page 134.
3. Verify that there is a LUN for communications. This can be either the CCL or
a LUN that was created with the CLI. See “What is the Command Console
LUN?” on page 38 in Chapter 1.
4. Install the Agent (TCP/IP network connections) on a system connected to the
HSG80 controller. See Chapter 3 for agent installation.
5. Add the name of the Client system to the Agent’s list of Client system entries
(TCP/IP network connections). This can be done during installation or when
reconfiguring the Agent.
6. Add the name of the Agent system to the Navigation Tree of each Client
system that is on the Agent’s list of Client system entries (TCP/IP network
connections). See Appendix B.
7. Set up pager notification (TCP/IP network connections). Refer to “Setting Up
Pager Notification” in the
HP StorageWorks Command Console Version
2.5, User Guide.