HP StorageWorks HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide (AA-RV1VA-TE, March 2005)

Installing and Configuring the HSG Agent
137HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide
Downloading the Host Kit Software From the Web
The host kit software is available for download. You can save the software to your
computer or create a CD-ROM. Platform kit software is stored on the download
web site based on operating system. Follow the steps below to obtain the software
from the web site.
1. Go to
http://h18006.www1.hp.com/products/storageworks/ma8kema12k/kits.html .
2. Select the kit for download.
3. Select the folder in which you want to save the file when presented with the
Save As dialog box.
Note: The folder you select must be large enough to store the OS kit selected. File
sizes range from 862KB to 51 MB depending on the operating system selected.
The platform kit software is available as an .iso or .zip file. After you download it
to your computer, your options are:
■ Create a CD-ROM using the .iso file.
■ Copy the .zip file to the server that runs the platform kit software.
Uncompress the file and run the install program on the server.
Installing and Configuring the Agent
The following instructions assume that you have a directory /mnt to which you
can mount the CD-ROM. If you do not, you must create a mount point and replace
/mnt in the following sequence with the mount point you created. It also assumes
your CD-ROM device is /dev/rz4c. If not, replace /dev/rz4c with the
actual CD-ROM device.
1. Obtain the following information:
— Names of systems you want the Agent to contact
— Names of subsystems connected to the host
— Email addresses for the Agent to send status updates
2. Insert the CD-ROM into a computer.
3. Enter one of the following commands at the command prompt: