HP StorageWorks HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide (AA-RV1VA-TE, March 2005)

Installing and Configuring the HSG Agent
138 HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide
— For V4.0x enter:
# mount -r -t cdfs -o rrip /dev/rz6c /mnt
(Substituting rz6c if necessary for your CD-ROM)
— For V5.1x enter:
# mount -r -t cdfs /dev/disk/cdrom0c /mnt
(Substituting cdrom0c if necessary for your CD-ROM)
4. Change directories on the CD-ROM by entering:
# cd /mnt/agent
Caution: The version of Compaq Tru64 UNIX that you are using, either V4.0x
or V5.1x will determine which
Device Special File Name format you will need
to enter.
5. To run the installation program, enter the following at the command prompt:
# setld -l .
Note: The -l is a lowercase L, and the period must appear at the end.
You are asked if you want to install the listed subsets.
6. Enter the corresponding number of the software and then press the Enter key.
Configure Client System Options
7. Select option y and then press the Enter key.
As the installation continues, you see several system messages, telling you
that the subset has been installed and is being loaded. The computer asks you
to add a client system entry.
8. Enter the name of the client system that you want to receive updates from this
Agent. Press the Enter key.
Note: Enter your most important client system first. Enter client systems that are
connected infrequently last. The Agent puts the client systems entered first at the top of
its list. It first contacts the client system located at the top of the list.