HP StorageWorks HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide (AA-RV1VA-TE, March 2005)

About this Guide
16 HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide
Chapter Content Summary
Table 1 below summarizes the content of the chapters.
Table 1: Summary of Chapter Contents
Chapters Description
1. Planning a
Subsystem
This chapter focuses on technical terms and knowledge needed to plan
and implement storage array subsystems.
2. Planning Storage
Configurations
Plan the storage configuration of your subsystem, using individual disk
drives (JBOD), storageset types (mirrorsets, stripesets, and so on),
and/or partitioned drives. This chapter describes addressing
conventions, configuration rules, creating storage profiles, and creating
storage maps.
3. Preparing the host
system
How to prepare your Tru64 UNIX host computer to accommodate the
HSG80 controller storage subsystem.
4. Installing and
Configuring the
HSG Agent
The Agent for HSG for a specific operating system polls the storage.
5. FC Configuration
Procedures
How to configure a subsystem that uses Fibre Channel (FC) fabric
topology. In fabric topology, the controller connects to its hosts through
switches.
How to verify that multiple paths exist to virtual disk units under Tru64
UNIX V5.1x.
6. Using CLI for
Configuration
How-to example of configuring a storage subsystem using the
Command Line Interpreter (CLI).
7. Ba ck ing Up,
Cloning, and
Moving Data
Description of common procedures that are not mentioned elsewhere in
this guide.
Backing Up Subsystem Configuration
Cloning Data for Backup
Moving Storagesets