HP StorageWorks HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide (AA-RV1VA-TE, March 2005)

177HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide
6
Using CLI for Configuration
This chapter presents an example of how to configure a storage subsystem using
the Command Line Interpreter (CLI). The CLI configuration example shown
assumes:
■ A normal, new controller pair, which includes:
— NODE ID set
— No previous failover mode
— No previous topology set
■ Full array with no expansion cabinet
■ PCMCIA cards installed in both controllers
A storage subsystem example is shown in Figure 40. The example system
contains three non-clustered TRU64_UNIX hosts, as shown in Figure 43. From
the hosts’ point of view, each host will have four paths to its own virtual disks.
The resulting virtual system, from the host’s point of view, is shown in Figure 43.