HP StorageWorks HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide (AA-RV1VA-TE, March 2005)

SWCC Agent in TruCluster Environment
227HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide
Running the SWCC Agent under ASE Services (UNIX 4.0 only)
In a TruCluster environment, use ASE Services to monitor the state of an
application. ASE Services can be used to automatically failover an application in
the event that the node running the application fails. Create this “Service” by
running the “asemgr” utility and answering the appropriate questions.
There are two steps to creating an ASE Service:
1. Create the Start/Stop scripts.
2. Create the service.
You can accomplish both steps by creating the Start/Stop scripts and then running
the asemgr to finish creating the service.
Note: When the ASE Director is started (for example during boot up) ASE Services run the Stop
scripts for all defined services by default. It then runs the
Start scripts for all defined services.
When writing Start/Stop scripts, one thing that should be apparent is scripts that toggle a
program’s run state will exhibit erratic behavior.