HP StorageWorks HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide (AA-RV1VA-TE, March 2005)

SWCC Agent in TruCluster Environment
253HSG80 ACS Solution Software V8.8 for Tru64 UNIX Installation and Configuration Guide
------------------ toggle ------------------
The SWCC Agent can run on a stand alone server or in a Tru64
TruCluster environment. The next question you will need to
answer determines arguments supplied to the Agent at startup. If
you are installing this Agent in a TruCluster environment answer
'Y' for yes. If you are not running TruCluster answer 'N' for
no.
REMEMBER: Only one instance of the Agent should run in a cluster
unless all HSZs and HSGs in the cluster are running firmware
versions that support the SWCC lock bit. See your HSx
documentation for more information.
For more information on switches see man page steamd.8.
Press 'Return' to Continue
Are you running the Agent in a cluster? [y,n] y
Setting 's' switch
SWCC5xx software installed successfully.
steamd config: Device Failover disabled
steamd config: Bus Scanning enabled, forcing initial scan
Agent Version: 2.3 (Build 77)
GetStgParms>> Scanning the bus for devices
Configuring “SWCC Agent 2.3 For Tru64 Unix” (SWCC5xx) on member0
Configuring “SWCC Agent 2.3 For Tru64 Unix” (SWCC5xx) on member1
Configuring “SWCC Agent 2.3 For Tru64 Unix” (SWCC5xx) on member2
# cd
# umount /mnt
# ps agx | grep steamd
540567 pts/1 S 0:00.11 /usr/opt/SWCC5xx/bin/steamd sF
540850 pts/1 S + 0:00.00 grep steamd