HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

Installing and Configuring HSG Agent
139HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
— Notification via TCP/IP socket
— Notification via SNMP protocol
— Notification via TCP/IP socket SNMP
■ Select the error notification level. You are notified based on this level. (You
must select one.)
— Fatal errors
— Warnings and fatal errors
— Info warnings and fatal errors
■ Select the subsystem access that the Client has. (This is used to control the
Client access into the subsystem. You must select one.)
— Overall system status
— Detailed status
— Configuration status
■ Start Installation, (Click on the Start Install button located in the lower right
corner of the screen.)
■ To Add or change the SWCC Agent configuration, use the Agent configure
script located in the
/opt/steam/bin dir called config.sh script.
Verify Entries
1. Select option 3 and press Enter.
The computer displays your choices, as shown in the following example:
Adding client--
name: <Host name>
access level: 2
error notification: 3
Is this information correct? [Y,n]
2. Verify the information, by typing Y or N, and press Enter.
The following is displayed:
Would you like to add another client? [y,N]
Configure CCL
3. Select option N and press Enter.