HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

151HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
5
FC Configuration Procedures
This chapter describes procedures to configure a subsystem that uses Fibre
Channel (FC) fabric topology. In fabric topology, the controller connects to its
hosts through switches.
The following information is included in this chapter:
■ "Establishing a Local Connection", page 152
■ "Setting Up a Single Controller", page 153
■ "Setting Up a Controller Pair", page 160
■ "Configuring Devices", page 168
■ "Configuring Storage Containers", page 169
■ "Assigning Unit Numbers and Unit Qualifiers", page 175
■ "Configuration Options", page 177
■ "Verifying Storage Configuration from Host", page 181
Use the command line interpreter (CLI) or StorageWorks Command Console
(SWCC) to configure the subsystem. This chapter uses CLI to connect to the
controller.To use SWCC for configuration, see the SWCC online help for
assistance.
Note: These configuration procedures assume that controllers and cache modules are
installed in a fully functional and populated enclosure and that the PCMCIA cards are
installed.
To install a controller or cache module and the PCMCIA card, see the HP
StorageWorks HSG60 and HSG80 Array Controller and Array Controller
Software Maintenance and Service Guide.