HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

Preparing the Host System
110 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
6. If any adapter drivers were loaded in previous steps, answer “Y” to allow the
Installation Manager to rescan your system for supported adapters. Since the
rescan will probe every possible I/O slot for new hardware, it can take up to 5
minutes to complete on a large system. During this time, a heavily loaded
system may appear to hang. This is normal.
7. System configuration files for adapters can be selected automatically or
manually.
— Choose “M” to manually edit your file. You can choose what FC adapters
and what targets will be supported. By default, LUNs 0 through 15 are
configured for each target that you select.
— Choose “A” to automatically edit the file. Support is added for all
supported Fibre Channel adapters, using the default SCSI targets.
— Choose “Q” to exit the Installation Manager.
After all the files have been loaded and edited, Installation Manager exits.
8. After RAID Manager is loaded, you are prompted to reboot your computer.
9. Change to the top level directory, by entering the following command:
# cd /
10. Enter the following command to shut down the computer:
# /etc/shutdown -y -i0 -g0
11. Wait for the OK prompt to appear, then enter the following (boot_device is
the name of your system disk):
# boot boot_device -r
12. Wait for your computer to perform a reconfiguration boot.
Note: While your computer is booting, you may see the following message:
WARNING:
/sbus@2,0/fcaw@1,0/sd@40,0 (sd32): corrupt label - wrong magic number.
This message appeared because a LUN you configured earlier is not yet labeled.