HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

Installing and Configuring the HSG Agent
119HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
Note: For serial and SCSI connections, the Agent is not required for creating virtual
disks.
Installation and Configuration Overview
Table 14 provides an overview of the installation.
Table 14: Installation and Configuration Overview
Step Procedure
1. Verify that your hardware has been set up correctly. See the previous
chapters in this guide.
2. 2 Verify that RAID Solution Software has been loaded properly. Refer to
Chapter 3.
3. 3 Verify that you have a network connection for the Client and Agent systems.
See “About the Network Connection for the Agent” on page 120.
4. 4 Verify that there is a LUN for communications. This can be either the CCL or
a LUN that was created with the CLI. See “What is the Command Console
LUN?” on page 39 in Chapter 1.
5. 5 Configure the SWCC Agent with the install.sh
or Config.sh
utilities. See “Configuring the Agent” on page 123
6. Add the name of the Agent system to the Navigation Tree of each Client
system that is on the Agent’s list of Client system entries (TCP/IP network
connections). See Appendix B.
7. Set up pager notification (TCP/IP network connections). Refer to “Setting Up
Pager Notification” in the
HP StorageWorks Command Console Version
2.5, User Guide.