HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

Installing and Configuring the HSG Agent
126 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
Adding a Subsystem Entry
Any storageset belonging to the subsystem can be used to add a subsystem entry,
but be careful not to delete the LUN from the subsystem when reconfiguring, as
this breaks the communication link to the Agent for the entire subsystem. Add the
subsystems you want the Agent to monitor by performing the following
procedure, starting at the RAID Array Configuration Menu.
1. In the Storage Subsystem Options group, select option 12, View
Subsystems.
An empty table appears. Before starting the Agent, add at least one subsystem
with which you want to communicate.
2. Select option 13, Add a Subsystem.
The subsystem name you enter is arbitrary, but use only lowercase characters
to specify it. Associate the name with a subsystem by picking a LUN name.
For example, c1t65d0, which the format
command output appears as
belonging to the RAID system. This is evident from the controller number and
SCSI target address used.
Append s2 to the device name (cxtydz) when entering the character
special file name, as a partition must be specified. Check that this
partition exists by entering format partition and format print
commands.
3. Enter a monitoring interval; for example, 30 seconds, and press Enter twice
to return to the RAID Array Configuration main menu.
Adding a Client System Entry
1. From the Client Options group, select option 16 to View Clients in the
authorized client list.
2. To add a client, select option 17, Add Client.
3. Enter the client’s network name (for example, myhost).
4. Enter an Access level code. Specify 2 if the manager/client is allowed to
configure the subsystem.
5. Add an Error Notification Level (1 for TCP sockets, 2 for SNMP, or 3 for
both).