HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

FC Configuration Procedures
146 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
Verifying Installation
To verify installation for your Sun Solaris host, reboot your system with the -r
option (reconfigure boot). After the system is booted, use the
format command to
verify that your LUNs are accessible.
Configuring Devices
The disks on the device bus of the HSG80 can be configured manually or with the
CONFIG utility. The CONFIG utility is easier. Invoke CONFIG with the
following command:
RUN CONFIG
WARNING: It is highly recommended to use the CONFIG utility only at
reduced I/O loads.
CONFIG takes about two minutes to discover and to map the configuration of a
completely populated storage system.
Configuring Storage Containers
For a technology refresher on this subject, refer to “Choosing a Container Type”
on page 72.
In choosing a container, you choose between independent disks (JBODs) or one
of several storageset types, as shown in Figure 40. The independent disks and the
selected storageset may also be partitioned.
The following configurations are detailed in the following sections:
■ Configuring a Stripeset, page 147
■ Configuring a Mirrorset, page 148
■ Configuring a RAIDset, page 148
■ Configuring a Striped Mirrorset, page 149
■ Configuring a Single-Disk Unit (JBOD), page 150
■ Configuring a Partition, page 150