HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

FC Configuration Procedures

150 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide

See “Specifying Initialization Switches” on page 89 for a description of the

initialization switches.

4. Verify the striped mirrorset configuration:

SHOW STRIPESET-NAME

5. Assign the stripeset mirrorset a unit number to make it accessible by the hosts.

See “Assigning Unit Numbers and Unit Qualifiers” on page 152.

For example:

The commands to create Stripe1, a striped mirrorset that comprises Mirr1, Mirr2,

and Mirr3, each of which is a two-member mirrorset:

ADD MIRRORSET MIRR1 DISK10000 DISK20000

ADD MIRRORSET MIRR2 DISK20100 DISK10100

ADD MIRRORSET MIRR3 DISK10200 DISK20200

ADD STRIPESET STRIPE1 MIRR1 MIRR2 MIRR3

INITIALIZE STRIPE1

SHOW STRIPE1

Configuring a Single-Disk Unit (JBOD)

1. Initialize the disk drive, specifying any desired switches:

INITIALIZE DISK-NAME SWITCHES

See “Specifying Initialization Switches” on page 89 for a description of the

initialization switches.

2. Verify the configuration by entering the following command:

SHOW DISK-NAME

3. Assign the disk a unit number to make it accessible by the hosts. See

“Assigning Unit Numbers and Unit Qualifiers” on page 152.

Configuring a Partition

1. Initialize the storageset or disk drive, specifying any desired switches:

INITIALIZE STORAGESET-NAME SWITCHES

INITIALIZE DISK-NAME SWITCHES

See “Specifying Initialization Switches” on page 89 for a description of the

initialization switches.