Manualshelf

HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

ManualsBrandsHP ManualsSoftwareHP StorageWorks HSG80 ACS V8.xF to V8.8S Upgrade Software
171172173174175176177178179180
FC Configuration Procedures
171HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
Change the Number of LUNs per Target
When changing from loop to fabric mode, you need to supply the WWPNs.
Do you want to change the number of LUNs per Target? [y,N]
By default, the Solaris Platform kit software supplies LUNs 0-15 for a total of 16
LUNs per Target. This number is more than adequate for many purposes.
However, if you want to change the number of LUNs per Target, select y, and the
following prompt is displayed:
Enter the number of LUNs per Target in a range of 1..64
(default: 16):
Set the Target IDs
Either press Enter to accept the default value of 16 LUNs or enter the desired
value.
Do you want to change the Target Ids? [y,N]
The Loop Target defaults are 64 and 65. For a server that is communicating to
more than one subsystem, you need to have more than the two Targets. If you
select y, then the following prompt appears:
Enter Targets (n= none, default: 64, 65) :
The Fabric Target defaults are 0,1 (zero, one)
You now have three options:
■ Press Enter and accept the default Loop Target Ids of 64, 65.
■ Enter the new Target Ids. These Ids should be entered as decimal values,
separated by spaces. Up to 16 Targets can be entered, and each Target should
be in the range of 17—65.
■ Enter the letter, n to indicate that there are no Targets specified. The impact of
this action is very important as it will preserve the adapter in the mode
requested but will remove all the sd.conf entries for that driver. The result is
that the driver will no longer communicate with any Targets.
If you select fabric mode, then the next prompt will appear in an attempt to map
the Target Ids to the WWPNs.
■ You configured driver fcaw for Fabric Mode.
■ Provide Port ID (WWPN) for each default Target, otherwise the Target will
be suppressed.
■ Driver fcaw for adapter fcaw.
— Target: 64, WWPN: $$$$-$$$$-$$$$-$$$$