HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

FC Configuration Procedures
172 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
— Enter WWPN (n=none, RETURN=old value, if any):
5000-1fe1-0000-03f1
These prompts are provided for each Target that has been defined. The user has
three choices at this prompt:
■ Press Enter to restore the old value for the WWPN.
■ Enter the WWPN value for each Target.
■ Enter the letter, n. This value specifies that there are no WWPNs specified.
The impact of this action is very important as it will preserve the adapter in
the mode requested but will remove all the sd.conf entries for that driver. The
result is that the driver will no longer communicate with any Targets.
Accept/Reject Changes
At this point, all the modification prompts have been provided and the final
actions are to show a summary of the modifications and allow the user to accept or
skip the changes.
• Adapter: fcaw
Path: /pci@a,2000/fibre-channel@2
Mode: Loop
LUNs/Target: 8
Targets: 67,68
• Is this correct? [Y,n]
At this point, you have two options.
■ Press Y, then Enter to accept the adapter driver’s modification, including
changes to the sd.conf entries and the specific driver file, fca-pci.conf.
■ Enter n and discard the proposed changes. No changes will be applied to the
adapter and driver and everything remains as previously.
Since these changes impact the system level driver mode, LUNs and Targets, the
server must be rebooted with the ( -r) reconfigure switch. Enter the following
command:
# reboot -- -r