HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

FC Configuration Procedures
174 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
6. After reboot, enter the format command to see the intended Targets list. This
assumes that at least one unit has been created on the subsystems.
Fabric Configurations
Note: This procedure assumes that the Solaris platform kit is being loaded onto the
system and a specific mode of operation is being selected.
1. Load the Solaris Platform kit and select the Fabric mode for the driver when
prompted. There are no default WWPNs so the software will prompt for the
specific WWPNs. When entering the values, case is not important, but the
hyphenation is.
2. Reboot the system. This is the normal reboot after driver/kit installation.
3. Complete the installation as documented with
/opt/steam/bin/Install.sh
4. Verify that the destination subsystems controllers are configured for fabric
mode using the CLI.
5. If the Targets cannot be seen under the format command then a reboot --
-r of the server will be required. (This assumes that some change was made
to the server or controller.)
Reconfiguring from Loop to Fabric
Note: QLogic HBAs are supported in fabric-mode only.
Note: This procedure assumes that the Solaris platform kit is loaded and everything is
running as desired but a change of configuration is required.
1. Stop I/O to the subsystem. Perform backups, as required.
2. Remove the connections from the hub.
3. Reconfigure the controllers from loop to fabric mode using the CLI.