HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)
177HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
6
Using CLI for Configuration
This chapter presents an example of how to configure a storage subsystem using
the Command Line Interpreter (CLI). The CLI configuration example shown
assumes:
■ A normal, new controller pair, which includes:
— NODE ID set
— No previous failover mode
— No previous topology set
■ Two single-bus model 4214R disk enclosure shelves
■ PCMCIA cards installed in both controllers
A storage subsystem example is shown in Figure 41. The example system
contains three non-clustered Sun Solaris hosts, as shown in Figure 43. The
resulting virtual system, from the host’s point of view, is shown in Figure 43.