HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

Installing, Configuring, and Removing the Client
218 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
Installing the Client
The following restriction should be observed when installing SWCC on Windows
NT 4.0 Workstations.
If you select all of the applets during installation, the installation will fail on the
HSG60 applet and again on one of the HSG80 applets. The workaround is to
install all of the applets you want except for the HSG60 applet and the HSG80
ACS 8.5 applet. You can then return to the setup program and install the one that
you need.
1. In a SAN environment where you would need both HSG60 and HSG80
subsystems, StorageWorks recommends you install both, but one at a time.
This problem is not seen under Windows NT 4.0 Server.
2. Insert the CD-ROM into a computer running Windows 2000 with Service
Pack 3 or 4, or Windows NT 4.0 (Intel) with Service Pack 6.0A, or Windows
Server 2003 (32-bit).
3. Using Microsoft Windows Explorer, go to the top-level directory of SWCC
on the CD-ROM, and double-click setup.exe. The SWCC Setup window
will appear.
4. Select HSG80 Controller for ACS85 or newer menu option to properly install
SWCC client, and click Next.
Note: If the computer does not find a previous installation, it will install the SWCC
Navigation Window and the CLI Window.
5. Follow the instructions on the screen. After you install the software, the
Asynchronous Event Service (AES) starts. AES is a service that runs in the
background. It collects and passes traps from the subsystems to the
Navigation Tree and to individual pagers (for example, to show that a disk has
failed). AES needs to be running for the client system to receive updates.
Note: For more information on AES, see HP StorageWorks Command Console
Version 2.5, User Guide
.