HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

Installing, Configuring, and Removing the Client
220 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
Caution: If you remove the integration patch, HSG80 Storage Window V2.1
will no longer work and you will need to reinstall HSG80 Storage Window
V2.1. The integration patch uses some of the same files as the HSG80 Storage
Window V2.1.
Integrating Controller’s SWCC Storage Window with CIM
You can open the controller’s Storage Window from within the Windows-based
CIM version 4.23 by doing the following:
1. Verify that you have installed the following by looking in Add/Remove
Programs in Control Panel:
■ The HSG80 Storage Window for ACS 8.6 or later (Required to open the
correct Storage Window for your firmware).
■ The HSG80 Storage Window version 2.1 (StorageWorks HSG80 V2.1)
The CIM integration patch uses files in this program.CIM version 4.23.
■ CIM integration patch (HSG80 Insight Manager Shim).
2. Verify that you have installed the CIM Agent and the StorageWorks
Command Console HS-Series Agent on the same computer.
3. Add the name of the client system that has CIM to the Agent’s list of client
system entries and choose SNMP as a notification scheme.
4. Open Insight Manager.
5. To open the Server window, click on the device you want to observe in the
CIM Navigation window.
6. Click on the Mass Storage button in the Server window. The CIM Navigation
Tree is displayed.
7. Click on the + symbol next to RAID Storage System. The Navigation Tree
expands to display a listing called Storage System Information.
8. Double-click Storage System Information. You are given the status of the
system.
9. Click Launch. The controller’s Storage Window is displayed.