HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

Planning a Subsystem
40 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
Disabling the CCL
To disable the CCL in SCSI-2 mode, enter the following CLI command:
HSG80 > SET THIS_CONTROLLER NOCOMMAND_CONSOLE_LUN
To see the state of the CCL, use the SHOW THIS CONTROLLER/ OTHER
CONTROLLER command. Because the CCL is not an actual LUN, the
SHOW UNITS
command will not display the CCL location.
Enabling/Disabling CCL in SCSI-3 Mode
The CCL is enabled all the time in SCSI-3 mode. There is no option to
enable/disable.
Determining Connections
The term “connection” applies to every path between a Fibre Channel adapter in a
host computer and an active host port on a controller.
Note: In ACS Version 8.8-1, the maximum number of supported connections is 96.
Naming Connections
It is highly recommended that you assign names to connections that have meaning
in the context of your particular configuration.
Note: Some non-alpha /numeric characters may not work with some hosts.
One system that works well is to name each connection after its host, its adapter,
its controller, and its controller host port, as follows:
HOST1A1
HOST
NAME
PORT
CONTROLLER
ADAPTER