HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Preparing the Host System
111HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
RAID Array Fibre Channel system. These registry settings are required for single
host and Windows NT/Windows 2000/Windows Server 2003 (32-bit) Cluster
configurations.
Fibre Channel Switch
The Fibre Channel Setup Utility makes all the driver changes to support fabric
topology automatically.
Fibre Channel Hub
The default setting is to use soft addressing. If you desire a hard ALPA, use
lputilnt.exe to assign an ALPA based on the table below. StorageWorks
supports up to four servers on the same Arbitrated Loop and recommends using
the low numbered ALPAs for each Windows NT/Windows 2000/and Windows
Server 2003 (32-bit) FCA adapter. Each server must have a unique ALPA. The
recommendation follows:
Note: ALPA assignments are not applicable to a Fibre Channel Switch configuration.
NT/2000 Server ALPA Assignment
Server 1 1 0X01
Server 2 2 0X02
Server 3 4 0X04
Server 4 8 0X08