HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Preparing the Host System
113HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
Other Communication Methods
After initial set up, you will be able to connect and communicate with your
Enterprise Storage RAID Array Fibre Channel system over a network or the SCSI
bus.
■ SCSI Bus Connection. A local connection method allows you to connect to
your Enterprise Storage RAID Array Fibre Channel system over the SCSI
bus.
■ Network Connection. You can communicate with your Enterprise Storage
RAID Array Fibre Channel system over a TCP/IP network.
Installing StorageWorks Command Console Client
The minimum requirements to run StorageWorks Command Console Client are:
■ PC Requirements: Pentium, 120 MHz, 64 MB memory, 10 MB free disk
space, and CD-ROM drive
■ Operating System: Microsoft Windows NT 4.0, Windows 2000 and Windows
Server 2003 (32-bit).
Verify that you have SNMP service installed. Refer to Chapter 2 of the HP
StorageWorks Command Console Version 2.5, User Guide for further instructions.
The Command Console Client software is installed on your host system from the
StorageWorks Command Console CD-ROM. After you insert the CD-ROM, the
program should start automatically.
Note: If the program does not start after inserting the CD-ROM, go to the CD-ROM
drive directory and click LAUNCH.EXE.
The installation program provides one primary option: Solution Software for ACS
version 8.8. Select it to install the software.
From the Fibre Channel Solution Software menu that appears, select the
StorageWorks Command Console option. The StorageWorks Command Console
software will be automatically installed.
Launching Command Console Client
To start Command Console from the Windows Start menu, click the HSG80
Storage Window name. The choices provided at startup are: