HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Preparing the Host System
117HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
CLI window. First close the Storage Window, and establish a CLI connection.
To invoke a CLI Window from the Command Console Client's Start menu,
select Command Console, then the CLI Window option.
The Connection Selection Window appears. Select Serial. At the next window
select 9600 baud rate and click Connect to invoke the CLI window. Enter the
following command to disable the Communication LUN:
set this_controller nocommand_console_lun
Close the CLI Window. Return to the Windows Start Menu and select the
HSG80 Storage Window option to re-open the storage window.
7. Select the Connections tab.
Confirm the following:
— WINNT is selected
— Unit Offset should be between 0-99 for Host Port 1, and between 100-199
for Host Port 2 (if connected)
8. Select the Battery tab.
Note: Confirm that the battery is fully charged. If not, wait until it is fully charged
before using the system.
Creating Your First Virtual Disk
With SWCC, you can create a number of different types of logical storage units
called virtual disks on your Enterprise Storage RAID Array Fibre Channel
Subsystem. These include the following:
■ Single-device virtual disks (JBODs).
■ Striped virtual disks (RAID 0).
■ Mirrored virtual disks (RAID 1).
■ Striped mirrored virtual disks (RAID 0+1).
■ Striped parity virtual disks with floating parity disk (RAID 3/5).
Virtual disks are created using Command Console Virtual Disk Wizard.