HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Preparing the Host System
130 HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
Note: Do not Restart the system at this time.
4. Using your Secure Path Software CD-ROM, install Secure Path 3.1A or 4.0 in
accordance with the instructions provided with that product. Then apply the
Secure Path 3.1A Service Pack 2 download.
5. Using your Solution Software CD-ROM, click the Solution Software v8.8
for Windows NT/2000/Server 2003 link.
a. Click the Perform FCA Driver Update link to install the HBA driver.
b. Click the Fibre Channel Software Setup link, then choose one of the
Multi-Bus Fibre Channel setups, based on your configuration.
c. Click the SWCC link (optional) to install SWCC components.
6. Restart the updated cluster node.
7. Repeat Step 1 through Step 6 for the next cluster node.
8. Once all cluster nodes have been upgraded, using Cluster Administrator,
restore all Cluster Groups to their original Prevent Failback setting, and
restore storage groups to their original configuration.
Transparent Failover Configurations
The following procedures are applicable to transparent failover configurations
only.
New Installations
Note: For Silent Installation, see “Solution Software Silent Installation” on page 132.
1. Using your Solution Software CD-ROM, click the Solution Software v8.8
for Windows NT/2000 link.
a. Click the Perform FCA Driver Update link to install the HBA driver.
b. Click the Fibre Channel Software Setup link, then choose one of the
Transparent Fibre Channel setups, based on your configuration.
c. Click the SWCC link (optional) to install SWCC components.