HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Preparing the Host System
134 HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
At the Command Prompt (or from a batch file), the command should look like
setup.exe -s -f1<path>\setup.iss -f2<path>\setup.log
where the path after -f1 is to the Windows or Winnt directory and the path after
-f2 is to where you want the setup.log file to be generated.
To check the success of the installation, view the setup.log file. Under the
“ResponseResult” section, a successful install shows ResultCode=0.
If running setup.exe from the CD-ROM, the setup.log file will not be generated
unless the -f2 switch is used. Also, the -f1 switch will be required to point to
the setup.iss file.
Refer to Secure Path documentation for instructions regarding silent install for
that product.
Note: If updating ACS firmware, complete the upgrade after all Windows server
upgrades. Be sure to back up data before updating servers.
Note: Disconnect fiber cables before proceeding.
These procedures are only applicable to Secure Path Version 3.x products and
upgrades, and require Secure Path Version 3.1A Service Pack 2 or Secure Path
4.0.
To obtain Service Pack 2 for Secure Path Version 3.1A, visit the web site:
http://www.compaq.com/products/sanworks/secure-path/index.html
Component Identifier Program
Figure 35 and Figure 36 demonstrate this program. The screen shots illustrate
many of the details of the Component Identifier Program, with the exception of
the following additional information:
■ Cpqkgpsaver.exe is installed to the \storageworks\version folder.
■ A log file can be created that has more detailed information. The log file name
is SysInfo.log, and is located in the \storageworks\version folder.