Manualshelf

HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

ManualsBrandsHP ManualsSoftwareHP StorageWorks HSG80 ACS V8.xF to V8.8S Upgrade Software
131132133134135136137138139140
Installing and Configuring the HSG Agent
139HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
Installation and Configuration Overview
Table 13 provides an overview of the installation.
Table 13: Installation and Configuration Overview
Step Procedure
1. Verify that your hardware has been set up correctly. See the previous
chapters in this guide.
2. Verify that you have a network connection for the Client and Agent
systems.See “About the Network Connection for the Agent” on page 140.
3. 3 If you plan to connect the HSG80 to a computer running Windows NT 4.0,
Windows 2000, or Windows Server 2003 (32-bit) in SCSI-2 mode, you
must disable the Command Console LUN (CCL) and create a virtual disk by
using the command line interface (CLI). For information on how to disable
the CCL, See “Determining Connections” on page 42 in Chapter 1. For
information on how to create a virtual disk, see “Add Unit” in the
HP
StorageWorks HSG60 and HSG80 Array Controller and Array Controller
Software Command Line Interface (CLI) Reference Guide.
For all other connections, verify that the Command Console LUN has been
enabled. See “What is the Command Console LUN?” on page 41 in
Chapter 1.
4. Install the Agent (TCP/IP network connections) on a system connected to the
HSG80 controller. See Chapter 3 for agent installation.
5. Add the name of the Client system to the Agent’s list of Client system entries
(TCP/IP network connections). This can be done during installation or when
reconfiguring the Agent.
6. 6 Install the Client software on Windows Server 2003 (32-bit), Windows 2000
with Service Pack 3 or Service Pack 4, or Windows NT 4.0 with Service Pack
6A, and Windows Server 2003 (32-bit). See Appendix B.
7. Add the name of the Agent system to the Navigation Tree of each Client
system that is on the Agent’s list of Client system entries (TCP/IP network
connections). See Appendix B.
8. Set up pager notification (TCP/IP network connections). Refer to “Setting Up
Pager Notification” in the
HP StorageWorks Command Console Version
2.5, User Guide.